- 18
number field on the Service Menu Option 17) Machine Serial Number (defaults to
the VMC Board serial number). Your DEX interrogator may need to be initialized
prior to the first read to allow the vendor to be recognized.
Installing Peripherals
Coin and bill accepters as well as card readers and other MDB peripherals
should be installed and their function tested prior to placing the vendor into
service. Always turn OFF the Power Supply rocker switch (bottom of door under
Delivery Bin) before plugging or unplugging MDB peripherals.
Coin Mechanism/Changer
The Coin Changer mounts onto (3) screws on the back of the door inside the
security door. Make sure that all (3) mounting screws are tightened. The coin
changer harness can be plugged directly into the MDB harness (VMC location J8
MDB) or it can be plugged into the Bill Acceptor Y-Harness.
•
Fill all coin tubes until a coin from each tube overflows into the cash box.
Test the operation of the coin changer after filling the tubes.
•
If the display reads, “Machine Must Be Set Up”, program a selection, and
then insert coins and test the coin changer for proper operation.
•
While testing, push the coin return to verify that coins will dispense into the
coin return cup.
•
Coins may be dispensed by pressing the payout keys on Service Keypad
or by going to Service Menu Option 18) Fill / Dispense.
Bill Acceptor
Remove the lower block-off plate from the door by removing the four #8 nuts with
an 11/32-inch socket wrench. Install the Bill Acceptor onto the studs using the
four #8 nuts that had previously held on the block-off plate. Some bill validators
may require the use of stud extensions. These are usually supplied with the bill
validator and should be used only if necessary. Tighten all four nuts to secure
the assembly, then turn ON the vendor and test for proper operation.
Card Readers and Telemetry Systems
There are many card readers and telemetry systems available. Fastcorp has
tested many of these devices to insure compatibility with our software. On
occasion, a new product will be introduced which may require further testing to
insure compatibility. If you have any questions relating to your MDB peripherals,
please call Fastcorp Technical Service.
Card Readers may be installed directly above the Customer Keypad. Remove
the upper block-off plate and install on the four available studs using the four
block-off plate #8 retainer nuts and an 11/32-inch socket wrench.
*Note - Store the block - off plates in a safe place for future use.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
