- 22
6. Install the Price Stickers and then the Display Cards behind the
retainer tabs in the appropriate slots and on the Display Card
Holder.
7 Ice Cream Machines - install the Display Card Holder in front of the lower
Light Fixture. Align the light fixture and Card Holder. Tighten the wing
nuts.
BIN SETUP/ PLAN-O-GRAM
The Evolution Vendor utilizes a bin system to hold product. The bin system is
made up of a number of bins of various shapes and sizes. The type and size of
the bins depends on the size and shape of the products being vended. Every
machine comes preconfigured with a specific bin layout or bin plan-o-gram. The
configuration of the bin plan-o-gram inside your machine may be modified to
accommodate different size bins as your product line changes. If you have any
questions relating to modifying your plan-o-gram contact the Fastcorp Service
Department.
Product Loading:
Press “LOAD” on the Service Keypad. The Freezer Lid will open and the Robot
Arm will move to the rear cabinet loading position. Bins may be filled without
being impeded by the Robot Arm.
Press “CLOSE” on the Service Keypad when bins have been filled. The Robot
Arm will return to the front delivery position and the Freezer Lid will close. The
Health Timer will automatically be set to 75 minutes to allow the freezer to
recover from any possible temperature loss due to loading.
“Load” then “Close” will signal the VMC that the machine has been filled.
Load/Close will automatically set a Health Sensor delay for 75 minutes.
Notes:
It is important to program the bin selections located on the left as short bins;
the rest are tall bins. However,
short and tall bin locations may vary
based on the specific freezer in your machine.
The short bins are shaded
in Fig 8. If short bins are programmed as tall bins, the robot will make contact
with the bottom of the bins and attempt to pull them out, resulting in possible
machine failure (out-of-order). If tall bins are programmed as short bins, the
machine will only vend product based on the height of a short bin. The robot
will leave product at the bottom of the tall bin and flag it Out-Of-Product.
The vending travel limits on the Up/Down axis can be adjusted by going to the
Service Menu #21 Up Down Travel Limits and follow the prompts.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
