- 13
We install a protective wood perimeter barrier onto the skids at the base of the
cabinet to prevent damage from fork trucks during warehousing and transport.
REMOVE SHRINK WRAP FROM THE CABINET BEFORE STORING THE
VENDOR OUTSIDE.
Remove the Shipping Materials:
•
Use a screw gun with a #2 Phillips bit to remove the
Fastap
retainer
screws from the wood perimeter barrier at the base of the vendor.
•
Use a box cutter knife to cut the shrink wrap.
When cutting the shrink
wrap, make all cuts over the corner boards.
Failure to do so may
cause damage to the Power Supply Cord or Graphics.
•
Store corner boards, card board panels and wood base barrier for future
use.
The shipping skids that are installed onto the Evolution Vendor will accommodate
most pump jacks and vending machine lifting devices. It is unnecessary to
mount the machine onto a pallet for transport. The skids are held in place by the
(4) Leveling Legs.
Remove the Shipping Skids:
•
The shipping skids can be removed by lifting and supporting the vendor
with an approved lifting device and then remove the (4) leveling legs using
a 1 3/8-inch socket wrench. Re-install the leveling legs a minimum of ¾ -
inch. Store shipping skids for future use.
•
The shipping skids have kerfs cut through each end and between the
leveling legs to allow skids to be split in half and removed using a pry bar
if necessary. Splitting the skids will render them unusable. The shipping
skids will need to be replaced before the machine is moved, again.
PRECAUTIONARY NOTES
THE VENDOR MUST BE PROPERLY LOCATED AND LEVELED.
•
The vendor must be located on a solid, flat and level surface.
•
The floor must be capable of supporting the weight load of a fully stocked
machine.
•
The vendor must be positioned close enough to an electrical outlet so that
an extension cord is not necessary.
•
The vendor should be moved with a pallet jack, fork lift truck, or vending
machine dolly.
•
Due to the large size and weight of the vendor, never move the vendor
with a hand truck or stair climber.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | + 561-391-7200
