Farmi Forest CH27 ACC, Operation, Maintenance And Spare Parts Manual

Page: 9 / 128

9 CH27 ACR & ACC
ACCESSORIES
1. Independent hydraulic unit HD50
• Recommended for use if the tractor hydraulic output
is above or below the CH27 chipper oil requirement
of approximately 45 l/min.
• It is especially recommended for use with the chipper-
crane combination.
2. Oil cooler for the HD50 unit
• Recommended for use in contracting work and when
the chipper is being operated in extremely warm con-
ditions.
3. Cross breaker
• The purpose of the cross breaker is to shred long
branches and twigs when the raw material to be chip-
ped is, for example, whole trees or sawn surfaces.
• The cross breaker can be installed in place of the twig
breaker, which comes standard with the CH27. The
cross breaker is mounted using the same washers and
nuts as used for the twig breaker.
• Note! Use of the cross breaker reduces the chipper
discharge output by approximately 30%.
4. Hydraulic discharge pipe control
• Directing the discharge pipe by hydraulic motor and
controlling the lid by hydraulic cylinder
• This is done using the tractor’s own hydraulics, thus
allowing the operator to control the discharge pipe
from the tractor cab.
• Recommended for use in contracting work.
5. Radio control of chipper functions,
Teleradio Panther
• Radio control of chipper feeder device functions and
feed stop
• This is used when the feeding crane is mounted to a
machine other than the chipper itself.
• Radio control makes it possible to eliminate the use
of easily-damaged electrical cables between machines.
•
6. 3PSL crane mounting bracket and
hydraulic support legs
• The FARMI hydraulic crane can be mounted to the
chipper using the mounting bracket.
HD 50 Oil cooler Cross breaker
Hydraulic discharge pipe control
Radio control
Teleradio Panther
3PSL crane mounting bracket
and hydraulic support legs