Farmi Forest CH27 ACC, Operation, Maintenance And Spare Parts Manual

Page: 14 / 128

14 CH27 ACR & ACC
Noise from the chipper exceeds 70
db in operation. Wear ear protection!
1. People are not to ride on top of the chipper.
2. The chipper may not be used indoors.
3. The chipper must only be used to chip wood.
4. The chipper may not be used in nature reserves.
5. Avoid chipping in areas where noise and dust will disturb
the surrounding environment.
6. The chipping of highly flammable materials is ex-
pressly prohibited.
GENERAL SAFETY
INSTRUCTIONS FOR
THE CHIPPER
1. Please make sure any machine operator has the required
personal protective equipment: safety helmet, protec-
tive goggles, cut resistant safety boots and required
protective clothing.
2. The chipper must not be used without being mounted to
a tractor.
3. For mounting or dismounting the chipper, always turn off
the tractor and apply the parking brake before ente-
ring the area between chipper and tractor.
4. The chipper must be on a level, firm surface during ope -
ration.
5. Make sure all protective and safety devices of the chipper
are installed. Never remove any protective device du-
ring operation.
6. As compared to the tractor, the chipper must not be lo-
wered excessively. Otherwise, the PTO drive shaft
connection may loosen during operation.
7. It is not permitted to operate the chipper without feed
unit or feed hopper.
8. The material to be chipped must never be fed into a crane
fed chipper manually.
9. Indoor operation of the chipper is prohibited.
10. Always keep a safe distance to the discharge position of
the chips.
11. Detach the chipper from the tractor before performing
any maintenance or repair works. Caution! As a sole
exception, adjust the speed of the feed rollers of the
hydraulic feed with the machine running. For further
instructions, please see the instruction manual of the
feed unit concerned.
12. Do not remove, lock, disable or modify in any other way
the stop lever of the feed unit.
13. The feed hopper or the feed unit must not be mounted at
a higher or lower position as this would impede the
stop lever function.
WARNING
ATTENTION