Farmi Forest CH27 ACC, Operation, Maintenance And Spare Parts Manual

Page: 70 / 128

70 CH27 ACR & ACC
2
72 + 0,5
_
REPLACING THE SPLINED
SHAFT
1. Remove the upper chamber.
2. Remove the bearings. Welding damages the bearings.
3. Lift the cutting disk using a crane.
4. At a distance of 2 mm from the shaft end, grind a groove
of 15 mm depth into the shaft.
5. Heat the joint area, if necessary.
6. Move the splined shaft so that it comes loose and can be
removed.
7. Clean the shaft hole and install the new shaft.
8. Make a fillet weld up to the surface level with three runs.
Use ESAB 68.81, OK 48, OK Femax 38.65, or equi-
valent filler.
Grind a 15-mm-deep groove
about 2 mm from the end of
the shaft.
Replacing the splined shaft
Area to be heated
DISPOSAL OF THE MACHINE
When the operating life for the machine has come to an
end it must be disposed by using the methods which are
the least hazardous for the environment.
Follow the next instructions:
1. Organize the machine to a scrap processing company
where it can be crushed under supervision.
If the machine cannot be taken to a scrap processing com-
pany, act as follows:
1. Drain off the hydraulic oil carefully of the entire sys -
tem and transport the oil to a supervised waste oil
recycling center.
2. Take off all the rubber parts and transport them to
the scrap rubber collection point.
3. Transport the scrap metal to a scrap metal collection
point.
4. Take all electrical/electronic parts to an electrical
waste (E-waste) recycling point.