Com.X Administrator Guide
Page 129
Two Inbound routes:
•
Fixed incoming DID 8000 is routed to Company A's reception. This DID will be
assigned to BRI calls originating from Company A's BRI channels in a
FlexPath
•
Fixed incoming DID 9000 is routed to Company B's reception. This DID will
be assigned to BRI calls originating from Company B's BRI channels in a
FlexPath
FlexPaths:
•
companyA-in: Add a Start route that transforms incoming BRI calls without
DIDs to the reception extension and forward these to the Inbound routes.
•
companyA-in: Add a Match route that transforms incoming BRI calls with any
DID to the reception extension and forward these to the Inbound routes.
•
Assign Company A's BRI trunk groups to the companyA-in FlexPath
•
companyA-out: Include an internal route that facilitates dialing internal
extensions
•
companyA-out: Add a rule that matches outgoing numbers other than
extensions and routes them to the companyAout outbound route.
•
Assign Company A's extension ports to the companyA-out FlexPath
•
companyB-in: Add a Start route that transforms incoming BRI calls without
DIDs to the reception extension and forward these to the Inbound routes.
•
companyB-in: Add a Match route that transforms incoming BRI calls with any
DID to the reception extension and forward these to the Inbound routes.
•
Assign Company B's BRI trunk groups to the companyB-in FlexPath
•
companyB-out: Include an internal route that facilitates dialing internal
extensions
•
companyB-out: Add a rule that matches outgoing numbers other than
extensions and routes them to the companyBout outbound route.
•
Assign Company B's extension ports to the companyB-out FlexPath
Note: Inter-company calls are facilitated by default and can be accessed by directly
dialing a company's extensions (e.g. the receptionist for Company B could dial 8000
to reach the receptionist for Company A.) To disable this, create empty FlexPaths
that terminate service for cross-company numbers:
•
Company A: Create an empty FlexPath that Matches dial pattern 9XXX
•
Company B: Create an empty FlexPath that Matches dial pattern 8XXX
Note: This is a simplified example. FlexPath could also be used to match incoming
DID ranges and route these to separate inbound routes for different partitions.
Note: The incoming CID can also be prefixed with a custom name for inbound
routes. To configure this, access the FreePBX Inbound Route configuration (please
see section 6.5) and configure the 'CID name prefix' field.
©2010 –
2016
Far South Networks
