Fagor DDS APS-24, Hardware Manual

Page: 161 / 406

   Drives
3.
Ref.1912
· 161 ·
DDS
HARDWARE
X2 connector
10-pin connector of the compact drive and integrates the functions of the
power supply and the modular drive.
The following table shows the values for gap, tightening torque (wire entry
holes) and other data regarding the screw-on terminals of the aerial plug-in
connector for X2 according to drive model:
Specific of the power supply
With the Error Reset input (pin 3), it possible to remove the errors at a
c o m pa c t d r i v e . S e e “ r e s e t ta b l e e r r o r s ” o f c h a p t e r 1 4 o f t h e
“man_dds_soft.pdf” manual. Hence, activating this input (24 V DC)
eliminates the resettable errors.
If the cause of the error persists, the status display will show the same error
again.
But if it is a major error, it can only be eliminated by powering the unit off and
back on.
Pins 1 and 2 offer a 24 V DC output for the user.
The maximum output current is 100 mA.
Specific functions of the modular drive
Control signals. With the “Drive Enable” and “Speed Enable” inputs (pins 4
and 5) together with the velocity command, it is possible to govern the motor.
The consumption of these control signals is between 4.7 and 7 mA.
The following page describes the behavior of the drive depending on these
control signals.
The “Drive Ok” contact (pins 6 and 7) will stay closed as long as the compact
drive runs properly.
F. H3/114
Connector X2. Control.
T. H3/24 Aerial plug-in connector for X2. Technical data.
ACD|/SCD|CMC SCD
1.08|1.15|1.25|2.35|2.50 2.75
Connector data
Nr of poles 10 10
Gap (mm) 5.00 5.00
Min./max. tightening torque (N·m) 0.5/0.6 0.5/0.6
Screw thread M3 M3
Min./max. section (mm²) 0.2/2.5 0.2/2.5
Rated current In (A) 12 12
Connection data
Length to strip (mm) 7 7
1
2
3
4
6
5
7
8
0 V DC
PROG. OUT
9
10
1
10
+24 V DC
ERROR RESET
DRIVE ENABLE
SPEED ENABLE
DRIVE OK
OP5 · F01411 ·
x1