FabWeaver A530, User Manual

Page: 30 / 120

1
-4
Preparation for Use
1
3. Component Name
1
5
2
3
4
6
7
8
9
10
11
12
<
Front
> <
Back
>
13
7
No. Name Description
1 LCD Control Panel
Screen used to operate the printer.
Caution
- It is recommended to remove the protective film on the LCD control panel before
this panel.
2
Power Button
Press the button to turn on the power.
Press and hold the button (for 2 seconds or longer) to turn off the power.
Power Button Indicator Lamp On The power is On.
Flickering
(at a interval
of 1 s) The power can be turned on instantly. (Only if power cord
is connected.)
Caution
- When the printer is not used for a long time, disconnect the power
cord.
The lamp may flicker for a few seconds after the power cord is
disconnected.
Lamp Off Inactive mode (Power cord is disconnected.)
3
USB Port
To connect a USB flash drive that contains a file to print it.
4 Front Door Handle To open the front door
5 Top Door Handle To open the top door
6 Filament Box Connection Open the cover to connect the main body to the filament.
7 Carrying Handle
To hold and carry the printer
8 Main Power Switch Press “
ㅣ
” (ON) or “
○
” (OFF) to turn on or off the power.
9 Power Port To connect the power cord.
10 USB Cable Port To connect the printer to a computer through a USB cable.
11 LAN Port To connect to a network device through a network cable.
12 Vent Fan (with HEPA Filter) To discharge the heat inside the printer.
To remove fine particles generated during printing.
13 Junction Cover Remove the cover to resolve problems of carrying filaments.