FabWeaver A530, User Manual

Page: 24 / 120

Before using the Machine
16
11. USB Flash Drive
11.1 Notice for Electromagnetic Interface (EMI)
❖
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
❖
Information of User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
❖
Caution
Any changes or modifications not expressly approved by the manufacturer responsible for compliance could void the
user’s authority to operate the equipment.
❖
IC identification on Class of ITE
CANICES-3 (B) / NMB-3 (B)
❖
Specification of Compatible USB flash drive for fabWeaver
Please use the enclosed USB flash drive.
The enclosed USB flash drive is in FAT32 format. The fabWeaver 3D printer does not support USB flash drives in
NTFS format.
The warranty will not be valid if a 3rd party USB drive is used.