1.
Rotate the encoder to highlight the selection for the value or setting to be change (
a
on
figure 22
on the preceding page
):
IP address
— Interface 1 or 2, as applicable
Netmask 1 or 2
— Interface 1 or 2, as applicable
DHCP
— Interface 1 or 2, as applicable
Gateway
— Gateway
2.
Press the Enter button (
b
).
NOTES:
•
If DHCP is enabled, the IP address and Netmask settings are disabled.
Disable DHCP (steps
1
,
2
,
5
, and
6
) to change the IP address and Netmask
settings.
•
For a Gateway address, proceed to step
3
.
•
For DHCP, skip to step
5
.
•
For IP addresses and Netmask addresses, skip to step
9
.
3.
For a Gateway address
, Rotate the encoder as necessary to select the LAN port
(Interface 1 or Interface 2) to use as a gateway (
c
).
4.
For a Gateway address
, press the Enter button. The
Apply
control appears in the
LCD. Proceed to step
9
.
5.
To toggle DHCP on or off
, rotate the encoder as necessary to highlight the
Enable
DHCP
selection (
d
).
6.
To toggle DHCP on and off
, press the Enter button. The
Apply
control appears in the
LCD.
7.
If you enabled DHCP or you do not want to manually set the addresses, proceed to
step
15
.
8.
To manually set addresses after disabling DHCP, proceed to step
9
.
9.
Rotate the encoder to highlight the first or next octet that needs to be changed (
e
).
10.
Press the Enter button.
11.
Rotate the encoder to change the selected octet to the desired value (
f
).
12.
Press the Enter button. The highlight jumps to the next octet.
13.
Repeat steps
9
through
12
as necessary to change all octets.
14.
Press the Enter button.
15.
Rotate the encoder as necessary to highlight the
Apply
control (
g
).
16.
Press the Enter button (
h
).
JMP 9600 Media Player • Operation
27
