Extron electronics DTP CrossPoint 84, Setup Manual

Page: 7 / 34

Contents
Contents
Introduction ............................................... 1
About this Guide .................................................. 1
About the DTP CrossPoint Matrix Switchers ........ 1
DTP Input and Output Signals ......................... 3
Installation ................................................. 4
Rear Panel ........................................................... 4
Video Inputs and Outputs ................................ 5
Audio Inputs and Outputs ................................ 6
Serial and IR Insertion Connections ................. 7
Control Connections ........................................ 7
Switcher Reset ................................................ 7
Power .............................................................. 7
Additional Connector Information ..................... 8
Front Panel ........................................................ 12
Front Panel Operations ............................ 13
Creating a Tie .................................................... 13
Recalling a Preset .............................................. 14
Viewing Ties (and Muting Outputs) ..................... 14
Viewing and Adjusting Volume and Mic
Volume ............................................................. 14
Setting the Front Panel Locks (Executive
Modes) ............................................................. 14
Selecting Lock Mode 2 or Toggling
Between Mode 2 and Mode 0 ...................... 15
Selecting Lock Mode 2 or Toggling
Between Mode 2 and Mode 1 ...................... 15
Remote Control ........................................ 16
Selected SIS Commands................................... 16
Establishing a Network (Ethernet)
Connection ................................................... 16
Number of Connections ................................. 17
Establishing a USB Port Connection .............. 17
Host-to-Switcher Instructions ........................ 17
Common SIS Command Symbols ................. 17
SIS Command and Response Table for
Matrix Switcher Commands ............................. 18
Installing and Starting the Control Programs ...... 20
Installing the Programs .................................. 20
Starting the Product Configuration
Software ....................................................... 21
Starting the DSP Configurator Program ......... 22
Accessing the HTML Pages............................... 24
vii Technical Publications Standards and Styles • Contents