DTP CrossPoint 84 • Installation
6
TP Outputs 3 and 4
on page 4) Plug compatible Extron
SIG LINK
OUT
DTP receivers, XTP matrix switchers, or HDBaseT-enabled devices into these
RJ-45 ports using STP cables (see
on page 8 to wire the
connector).
ATTENTION:
•
Do not connect this port to a computer data or telecommunications network.
•
Ne connectez pas ces port à des données informatiques ou à un réseau de
télécommunications.
Audio Inputs and Outputs
4
Tx Rx G
S/PDIF
OUT
EXP
+48V
MIC/LINE
1
1
3
2
4
2
3
4
LINK
REMOTE
AUDIO INPUTS
AUDIO OUTPUTS
DMP EX
PA
NSIO
N
1
L
R
1
L
R
3
L
R
3
L
R
5
L
R
2
L
R
4
L
R
2
L
R
4
L
R
6
L
R
RESET
1
L
R
4
CLASS 2 WIRING
8
/
AMP OUTPU
T
Figure 4.
Video Output Features
Audio Inputs 1 through 6
— Plug balanced or unbalanced
L
R
stereo audio inputs into these 3.5 mm, 5-pole captive screw connectors (see
Local and Mic/Line audio connectors
to wire the connectors).
Mic/Line Inputs 1 through 4
— Plug microphones or other mono audio inputs
into these 3-pole, 3.5 mm captive screw connectors (see
to wire the connectors).
+48 V (phantom power) LEDs
— Light to in48 V
+48V
1
2
phantom power is switched on via software.
Audio Outputs 1 through 4
— Plug audio devices such an audio amplifier
L
R
or powered speakers to these 3.5 mm, 5-pole captive screw connectors
(see
Local and Mic/Line audio connectors
to wire the connectors).
Amp Output 1
(SA [stereo] model) — Plug passive, 4-ohm or 8-ohm
1
L
R
4
CLASS 2 WIRING
8
/
speakers to this 5 mm 4-pole captive screw connector to receive the
amplified audio from output 1.
Amp Output 1
AMP OUTPUT
1
CLASS 2 WIRING
Connect passive high-impedance speakers to this 2-pole captive sc
rew
connector to receive the amplified audio from output 1.
S/PDIF Output 4
— Plug a compatible device
into
this RCA connector
S/PDIF
OUT
with a 75-ohm digital audio cable to receive a digital audio signal from the
output 4 digital stream.
DMP Expansion Port and LED
—
EXP
LINK
Expansion Port
— Plug an STP cable between this port and the
Expansion port on an optional Extron DMP 128 ProDSP Digital Matrix
Processor.
Link LED
— Lights to indicate that the port is connected to a compatible device.
DTP Outputs 3 – 4
4
Audio Inputs 1 – 6
Mic/Line Inputs 1 – 4
+48 V LEDs
Audio Outputs 1 – 4
Amp Output 1 (SA model)
Amp Output 1 (MA model)
S/PDIF Output 4
DMP Expansion Port and LED