Extron electronics DTP CrossPoint 84, Setup Manual

Page: 17 / 34

DTP CrossPoint 84 • Installation 9
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable. A cable that is wired the same at both ends is
called a "straight-through" cable, because
no pin/pair assignments are swapped.
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
Pin
1
2
3
4
5
6
7
8
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
End 1 End 2 End 1 End 2
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
Pin
1
2
3
4
5
6
7
8
Wire color
White-orange
White-green
Blue
White-blue
White-brown
Brown
Wire color
T568B T568B
White-orange
Orange Orange
White-green
Blue
White-blue
Green
Green
White-brown
Brown
LAN Ports DTP I/O Ports, Expansion Port, and LAN Ports
Crossover Cable Straight-through Cable
Figure 7. RJ-45 Connector and Pinout Tables
NOTES:
•
Do not use standard telephone cables. Telephone
cables do not support Ethernet or Fast
Ethernet.
•
Do not stretch or
bend cables. Transmission errors can occur.
LAN ports
The LAN ports require Category (CAT) 3, CAT 5e, or CAT 6a unshielded twisted pair (UTP)
or shielded twisted pair (STP) cables, crossover or patch cables.
The cable used depends on your network speed. The switcher LAN port supports both 10
Mbps (10Base-T — Ethernet) and 100 Mbps (100Base-T — Fast Ethernet), half-duplex and
full-duplex Ethernet connections. Input and output boards support 100Base-T only.
• 10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.
• 100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at minimum.
For ports on an IPCP module, see the
IPCP Pro Series User Guide
at www.extron.com to
make all network connections and to configure and operate the IPCP control processor.
DTP and Expansion ports
The DTP input and output ports are compatible with Extron XTP DTP 24 SF/UTP cables, as
well as CAT 5e, 6, 6a, and 7 shielded twisted pair (F/UTP, SF/UTP, and S/FTP) cable. The
Expansion port requires CAT 5e, 6, 6a, or 7 shielded twisted pair cable.
For the Expansion port only —
ATTENTION:
•
Connect this port to the Expansion port on a compatible Extron DMP processor. Do NOT connect
this port to a LAN or Power over Ethernet port; equipment damage can occur.
• Connectez ce port au port d’expansion sur un processeur DMP d’Extron
compatible. Ne connectez
PAS
ce port à un port LAN ou d’alimentation via
Ethernet ; le matériel pourrait être endommagé.
7