Altitude 3500 Series Access Point Product Reference Guide
584
Configuring a VPN Tunnel Between Two Access Points
The access point can connect to a non-AP device supporting IPSec, such as a Cisco VPN device—labeled
as “Device #2”.
For this usage scenario, the following components are required:
●
2 access points (either an Altitude 3510 or Altitude 3550 model)
●
1 PC on each side of the access point’s LAN.
To configure a VPN tunnel between two access points:
1
Ensure the WAN ports are connected via the internet.
2
On access point #1, select
WAN
>
VPN
from the main menu tree.
3
Click
Add
to add the tunnel to the list.
4
Enter a tunnel name (tunnel names do not need to match).
5
Enter the WAN port IP address of AP #1 for the
Local WAN IP
.
6
Within the
Remote Subnet
and
Remote Subnet Mask
fields, enter the LAN IP subnet and mask of AP #2
/Device #2.
7
Enter the WAN port IP address of AP #2/ Device #2 for a
Remote Gateway
.
8
Click
Apply
to save the changes.
Summary of Contents for Altitude 3500 Series
