Extreme Networks Altitude 3500 Series, Product Reference Manual

Page: 583 / 594

Altitude 3500 Series Access Point Product Reference Guide
583
or the firmware file name. If T136 is not specified, the access point uses the entire bf field as the
config file name.
NOTE
The update process is conducted over the LAN or WAN port depending on which Server responds first to
the access point’s request for an automatic update.
NOTE
If the firmware files are the same, the firmware will not get updated. If the configuration file name matches
the last used configuration file on the access point or if the configuration file versions are the same, the access
point configuration will not get updated. The LAN Port needs to be configured as a BootP client. There's no BootP
support on the WAN Port. The WAN supports only DHCP.
BootP Priorities
The following flowchart displays the priorities used by the access point when the BootP server is
configured for multiple options:
If the BootP Server is configured for options 186 and 66 (to assign TFTP server IP addresses) the
access point uses the IP address configured for option 186. Similarly, if the BootP Server is configured
for options 188 and 129 (for the configuration file) the AP uses the file name configured for option 188.
Configuring an IPSEC Tunnel and VPN FAQs
The access point has the capability to create a tunnel between an access point and a VPN endpoint. The
access point can also create a tunnel from one access point to another access point.
The following instruction assumes the reader is familiar with basic IPSEC and VPN terminology and
technology:
●
Configuring a VPN Tunnel Between Two Access Points on page 584
●
Configuring a Cisco VPN Device on page 586
●
Frequently Asked VPN Questions on page 587