21
4.0 Structure a n d fun ctio n
WARNING
Safety hazard caused by wrong attachment
The front bracket is designed and tested to be working with
the load in axial direction. If the customer wnts to attach the
attachement placed in a radial way, it is under his responsibility
to verify the strength of the support structure and the screw
attachment.
Detailed requirements like the tightening torque and the strangth
class are specified in chapter 6.4 Installation (⮑ page 29).
Disregard of the installation guide coud have serious impact to
safety and/or operation of the device.
The rear bracket comes as standard attached to the CAMT
protection tube through 2 large pivot pins/bushings
(⮑ fig. 13).
The rear bracket fits to the size of the outer tube of several
Ewellix telescopic pillars and it should be fastened using 6
standard M10 screws.
Fig. 13
WARNING
Safety hazard caused by wrong attachment
The front bracket is designed for a direct attachment to the
following Ewellix telescopic pillars: CPMT, TLG and TLT.
However, it could also be attached to en adapter plate or a
support structure.
Detailed requirements like the tightening torque and the strangth
class are specified in chapter 6.4 Installation (⮑ page 29).
Disregard of the installation guide coud have serious impact to
safety and/or operation of the device.
4.4.4 Degrees-of-freedom (2-DOF)
brackets
The front bracket is attached to the CAMT spindle through a
Ø8 dowel pin and allows for a dual axis movement
(⮑ fig. 14). The 2 axis free in rotation being in a cartesian
coordinate system, the 2 complementary axis, perpendicular
to the main spindle axis.
The dowel pin is fixed relatively to the spindle and the
bracket swivels around it, supported by 2 bushings. Starlock
washers act as backup device in the eventuality that over
time, the pin press-fit connection was to get lose, keeping it
in place.
Fig. 14
WARNING
Safety hazard caused by wrong attachment
The front bracket is designed and tested to be working with
the load in axial direction. If the customer wnts to attach the
attachement placed in a radial way, it is under his responsibility
to verify the strength of the support structure and the screw
attachment.
Detailed requirements like the tightening torque and the strangth
class are specified in chapter 6.4 Installation (⮑ page 29).
Disregard of the installation guide coud have serious impact to
safety and/or operation of the device.
Summary of Contents for CAMT20
Page 1: ...CATEGORY MAX 2 LINES INSTALLATION OPERATION AND MAINTENANCE MANUAL CAMT20 Linear actuator...
Page 2: ......
Page 45: ......
