28
CAMT 20
6.0 Installation and first operation
This chapter is intended for technicians and those involved
with further processing. It provides the information needed
to assemble, connect and start up the device.
6.1 Safety
Qualification (refer to chapter ⮑ 2.3.1 Qualification, page 7)
Authorized personnel
• The installation and first start of operation may only be
conducted by qualified persons.
• Work on the electrical system may only be performed by
trained professional electricians.
WARNING
Electric shock and moving parts hazards.
Serious injury or death can be caused by touching live electrical
componenets and by unexpected movement of the actuator.
Be sure the system's power supply is off and the actuator is
locked out before installing.
WARNING
Danger if restarted without autorization
When correcting faults ithere is a danger of the energy supply
being switched on without authorization. This poses a life
threatening hazard for persons in the danger zone.
Therefore:
• Prior to starting work, switch off the system and safeguard it from
being lockout.
WARNING
Risk of injury and device damage due to incorrect
installation of the optional devices
Therefore:
• Optional devices, in particular components that are part of a ret-
rofitting, may only be installed in accordance with the respective
instructions (circuit diagram).
• The electromagnetic compability must be tested for the routing
and appropriate measures must be carried out if necessary.
WARNING
Special precautions regarding EMC
The device requires special precautions regarding EMC and
must be installed and put into service according to the EMC
information provided in this manual
(refer to chapter ⮑ 2 Safety, page 6).
6.2 Installation location
Adhere to the technical data in accordance with operating
conditions.
Install in a location according to the ambient operating con-
ditions and where the devices are not exposed to strong UV
radiation or corrosive or explosive air media.
6.3 Inspections prior to
initial operation
Perform an installation check before you start up the system
with operating devices for the first time:
• To be performed by a professional electrician
• Prior to first operation, a professional electrician must per-
form and document the following tests and readings:
-
Visual condition check
-
Function check of operating features and safety features
-
Reading of leakage currents
-
Reading of insulation resistance
NOTE
Additional information concerning inspections and readings
(refer to chapter ⮑ 8 Maintenance, page 35).
WARNING
Crush hazard
Risk of damage to the linear actuator CAMT caused by static
and dynamic overload. Do not use the actuator beyond the
permissible operaring data.
• Note the maximum permissible operating data in the datasheet
• Note the product label of the actuator (end warning box)
Summary of Contents for CAMT20
Page 1: ...CATEGORY MAX 2 LINES INSTALLATION OPERATION AND MAINTENANCE MANUAL CAMT20 Linear actuator...
Page 2: ......
Page 45: ......
