Ewellix CAMT20, Installation, Operation And Maintenance Manual

Page: 26 / 46

26
CAMT 20
5.0 Transport, packaging and
storage
5.1 Safety information for
transportation
CAUTION
To prevent damage due to improper transport.
• Proceed carefully during delivery and unloading of the packaged
items, as well as during the transport to final destination. Comply
with the symbols and information shown on the packaging.
• Do not remove the Operating elements and Accessories from its
packaging until just before installation.
• Note storage requirements for return transport of the device to
the manufacturer.
5.2 Transport inspection
The linear actuators are delivered as one packaged unit in a
plastic bag, box or on pallets. Check the delivery immedi-
ately upon receipt of the delivery, for completeness and any
signs of damage incurred during transport.
Check completeness of delivery for:
• A complete linear actuator with built-in options as defined
by the Type key on the type plate.
• Installed cable and low voltage connector (depending on
the option chosen, with DIN-8 connector or flying leads).
• Any signs of damage to the plastic casing, such as cracks.
If exterior transport damage is evident:
• Do not accept delivery or accept with exceptions (due to
fulfill orders)
• Record scope of damage on the transport documents or
bill of delivery of the shipping company
• Initiate complaint
NOTE
Report any damage as soon as possible, as damage claim can
only be submitted within the transporter's applicable
complaint period.
5.3 Return to the
manufacturer
If device is damaged, arrange for return transport as
followst:
1. Dismantle the device if necessary (refer to chapter
⮑ 10 Dismantling, page 40).
2. Pack device in its original packaging. Follow storage
conditions (refer to chapter ⮑ 5.5 Storage, page 27).
3. Send to manufacturer. Contact Ewellix service to obtain
a shipment address.
5.4 Packaging
Requirements:
All parts are packaged appropriately for anticipated trans-
port conditions, using only environmentally-friendly packag-
ing materials.
The packaging is intended to protect the individual compo-
nents from damage caused during transport, or by corrosion
and other potential hazards, until the components are ready
for installation. Only remove packaging shortly before instal-
lation. The packaging should not be destroyed, but kept for
possible return shipment to the manufacturer (refer to chap-
ter ⮑ 5.3 Return to the manufacturer, page 26).
If the packaging is to be disposed of, please note and ad-
here to the following notices:
NOTE
Environmental damage due to incorrect disposal
Packaging material consist of valuable materials, much of which
can effectively be recycled and reused.
Therefore:
• Dispose of packaging material in an environmentally correct way
• Comply with locally applicable disposal requirement