EVS Synapse GED100, Manual

Page: 46 / 74

#RfMode RfMode has the same options as Line, but each option is 11dB more sensitive, to
avoid overloading the RF input of a television. Options are:
None , Film stnd , Film
light , Music stnd , Music light and speech .
You can also choose to use the metadata settings in the external program (Ext_
meta).Default is Ext_meta.
#Line Line sets the Dynamic range metadata of presets.
• NONE no dynamic range compression is applied unless downmixing could
cause overload, in which case protection dynamic range is automatically
applied.
• Film stnd applies more compression to a subjectively loud film that requires
dynamic range restriction.
• Film Light applies light compression to a subjectively quiet film that does not
require dynamic range restriction.
• Music Stnd applies more compression to music that is not compressed and
requires dynamic range restriction.
• Music light applies light compression to music that is already compressed
and does not require excessive dynamic range restriction.
• Speech is appropriate for programs with predominantly dialogue.
You can also choose to use the metadata settings in the external program (Ext_
meta). Default is Ext_meta.
MD_Status_Src In the status menu, the status of all the metadata parameters of one metadata set
can be monitored. With this setting you select which metadata set you want to
monitor. Can be the ShufflerOut, DecoderOut, Local or SDI. Refer to schematic in
the Metadata header of the metadata settings for a visual explanation. Can also
be switched to
off , in which case there will be no status monitoring of metadata
(default).
MD_Status_Pgm With this item you select which program out of the above selected metadata set
you want to monitor. Can be 1 through 8. Default is 1.
RestartCAT561 With this setting you can reset the Dolby board (CAT561) without resetting the
Synapse board. When switched to
Reset , the setting will automatically go back to
No Reset after the CAT board is restarted.
SMPTE ST 352 Video Payload Identifier
The SMPTE ST 352 Video Payload Identifier, also known as VPID, is transported within the ancillary data
of an SDI stream. The ancillary packet is placed in the HANC space. This packet contains 4 bytes of
data.
There are two versions of the standard. The first was published in 2011 and the second in 2013. The
revision can be seen within the 4 bytes.
When the GED100 is not processing the incoming VPID packets, they will be passed transparently. When
it generates the packets, the GED100 will output VPID packets using the 2013 standard.
38 | November 2021 | Issue 1.00.B