Evoqua WALLACE & TIERNAN GMS PLUS, Original Instruction Manual, Page: 86 / 116

86
WT.050.455.000.DE.IM.0319
Operation
GMS
plus
6.
Display
Value range
(factory setting, bold)
Description
SENSOR II Setting the parameters for the sensor to be
connected to sensor channel II
Sensor input II Chloratect
mA signal
OFF (all menus for sensor channel I
are hidden and the associated
measured values are not displayed.)
Selection of sensors to be connected
Sensortype II For mA sensors:
Cl2 , ClO2, O3, SO3, HCL, ----
(variably definable type, max. 4
positions)
For Chloratect sensors (µA-Input):
Cl2 , ClO2 and O3
Setting the sensor type (i.e. the gas to be
measured)
Type def II XXXX Enter the sensor type for sensor II
for variable definition (A – Z, a – z, 0 – 9)
4 positions (freely selectable)
Sensor unit II ppm
ml/m
3
---- (unit freely selectable, max. 4
positions for mA sensors)
Sensor II display unit
Unit def. II XXXX Entering the sensor unit for mA sensor II
for variable definition (A – Z, a – z, 0 – 9)
4 positions (freely selectable)
Range Start II 0 – 999 (mA sensor)
0.0
Measuring range start value for mA signal
sensor II
Measuring Range II/
Range End II For mA sensors: 0...999
Display format 000.0 for value over
100
Display format 000 for values higher
than 100
or
For Chloratect sensors:
end value 1.5 or 20 ppm
O3 =>
1 ppm
Cl2 => 5 ppm / 20 ppm
ClO2 => 5 ppm / 20 ppm
Setting the measuring range for Chloratect
sensors and/or setting the measuring range
end value for mA sensors
Factor II 0.1 – 4.0 (for mA signal sensor)
1.0
Factor for adjusting the measuring range of
sensor II to range II of the GMS
plus
Temperature II OFF /ON Temperature measurement II on/off