Evoqua WALLACE & TIERNAN GMS PLUS, Original Instruction Manual, Page: 85 / 116

GMS
plus
Operation
6.
85
Display
Value range
(factory setting, bold)
Description
SENSOR I Setting the parameters for the sensor to be
connected to sensor channel I
Sensor input I Chloratect
mA signal
OFF (all menus for sensor channel I
are hidden and the associated
measured values are not displayed.)
Selection of sensors to be connected
Senso type I For mA sensors:
Cl2 , ClO2, O3, SO3, HCL, ----
(variably definable type, max. 4
positions)
For Chloratect sensors (µA-Input):
Cl2 , ClO2 and O3
Setting the sensor type (i.e. the gas to be
measured)
Type def I XXXX Enter the sensor type for sensor I
for variable definition (A – Z, a – z, 0 – 9)
4 positions (freely selectable)
Sensor unit I ppm
ml/m
3
---- (unit freely selectable, max. 4
positions for mA sensors)
Sensor I display unit
Unit def. I XXXX Entering the sensor unit for mA sensor I
for variable definition (A – Z, a – z, 0 – 9)
4 positions (freely selectable)
Range Start I 0 – 999 (mA sensor)
0.0
Measuring range start value for mA signal
sensor I
Measuring Range I/
Range End I For mA sensors: 0 – 999
Display format 000.0 for value over
100
Display format 000 for values higher
than 100
or
For Chloratect sensors:
end value 1.5 or 20 ppm
O3 =>
1 ppm
Cl2 => 5 ppm / 20 ppm
ClO2 => 5 ppm / 20 ppm
Setting the measuring range for Chloratect
sensors and/or setting the measuring range
end value for mA sensors
Factor I 0.1 – 4.0 (for mA signal sensor)
1.0
Factor for adjusting the measuring range of
sensor I to range I of the GMS
plus
Temperature I OFF /ON Temperature measurement I on/off