Evoqua WALLACE & TIERNAN GMS PLUS, Original Instruction Manual, Page: 57 / 116

GMS
plus
Installation
5.
57
5.5 Commissioning the mA sensor
Remove the protection cap
Please note
The sensor opening protection cap must be removed before
commissioning the sensor!
Proceed as follows:
1 Remove the sensor opening protection cap.
Installing the mA sensor 2 Secure the sensor cable (2 m) or sensor cable (10 m) to
terminal 19 (red) and 20 (blue).
Channel II => terminal 23 (red) and terminal 24 (blue).
3 Connect the BNC plug into the mA sensor.
Please note
During the run-in time the sensor adapts to the environmental
conditions.
4 In the menu"SENSOR I", parameter "Sensor input I" , set the
"mA Sensor".
5 In the menu "Sensor type I", set sensor types"Cl2", "ClO2",
"O3", etc. and/or select the variably definable sensor type"----"
.
You may define four characters for the variable sensor type.
6 In the menu "Sensor unit I", select the desired unit or variably
definably unit "----".
You may define four characters for the variable unit.
7 Set the measuring range-initial value (see sensor data sheet).
A
B
C
A Sensor opening
B Protection cap
C Base
A
A BNC plug