5 - 11
5
590SP Digital Product Manual
Chapter 5 Troubleshooting
Bit
Alarm
Hex Value
Inhibit?
Delay Time
11
P3 Port
0x0800
no
---
12
Stall Trip
0x1000
yes
---
13
Overcurrent Trip
0x2000
no
---
14
not used
0x4000
---
---
15
not used
0x8000
---
---
This example shows how HEALTH WORD, HEALTH STORE, and LAST ALARM are updated.
During operation, the controller trips on P3 PORT ALARM (0x0800), the drive loses three-phase power when an SCR
fuse blows (0x0200) and the motor overheats causing the thermistor to open (0x0010). HEALTH WORD is:
0x0010 = 0x0A10.
HEALTH WORD
HEALTH STORE
LAST ALARM
0x0A10
0x0800
P3 PORT ALARM
During troubleshooting, the motor cools down and the thermistor closes.
HEALTH WORD
HEALTH STORE
LAST ALARM
0x0A00
0x0800
P3 PORT ALARM
The P3 PORT ALARM is cleared and the drive is restarted and immediately trips with a 3 PHASE FAILED alarm.
HEALTH WORD
HEALTH STORE
LAST ALARM
0x0200
0x0200
3 PHASE FAILED
The fuse is replaced and three-phase power is turned on.
HEALTH WORD
HEALTH STORE
LAST ALARM
0x0000
0x0200
3 PHASE FAILED
The drive is restarted.
HEALTH WORD
HEALTH STORE
LAST ALARM
0x0000
0x0000
3 PHASE FAILED
NOTE. Before restarting a drive after troubleshooting the first alarm, it is good practice to monitor
HEALTH WORD to assure all alarms have been cleared. This can reduce down time.
Summary of Contents for 590SP
