590SP Digital Product Manual
App. G - 5
Appendix G RS232 System Port (P3)
G
The 5703 also supports master/slave ratioed speed locking, although the unit is not intended to supplant Quadraloc—
which integrates external speed/phase and position locked loops— in applications requiring absolute speed or position
control.
Hardware Description
The 5703 is housed in a DIN rail mountable box and is provided with a “ribbon” cable to connect into the controller’s
RS232 port. Fiber optic cable interconnects the speed signal from unit to unit. A connection diagram is shown in
Figure G.3.
NOTE. To limit transmission errors, the ribbon cable length must not exceed 4 meters.
The 5703 unit converts RS232 electric data signals into light; it does not alter or modify the signals in any other way.
The drive software within the motor controller interprets the received electrical data as a speed reference signal.
The 5703 has one fiber optic receiver and two fiber optic transmitters. The fiber optic receiver RX1 receives data from
the “preceding” unit. The primary transmitter TX1 always sends data to the “follower” unit from the "master" unit
transmitting through the 5703's RS232 port. The additional fiber optic transmitter TX2 retransmits the incoming signal
at RX1, or provides a second output signal for the "master" RS232 reference, giving the unit wide functionality. A link
determines the function of the TX2. When the link is connected to positions 1 and 2, TX2 repeats the signal received
at RX1. When connected to positions 2 and 3, it sends the same output signal as TX1, or the data transmitted through
the RS232 port. Figure G.2 shows the 5703 board layout and the two link positions.
The settings under the MMI sub-menu 5703 SUPPORT determine how the drive interprets the data transmitted and
received between the 590SP P3 port the 5703 RS232 port. Refer to the Installation Instructions (HG351943) included
with the Peer-to-Peer Communications Option for further configuration settings and application information.
Figure G.3 - 5703 Connection Drawing (Shown on a 590SP)
Summary of Contents for 590SP
