Euphonix MixView CS2000, Operation Manual

Page: 77 / 324

Section 4: Tutorial
Euphonix CS3000/2000 Operation Manual 4 - 7
F3 F1 F2 F4
F3 F1 F2 F4
**CH->Aud:OFF Aud->OFF
Mode I/O Master
Meter Config Menu
Meter Menu
F3 F1 F2 F4
F3 F1 F2 F4
1CH->Aud:OFF Aud->OFF
1CH-> OUTs METER Route
The two asterisks (**) preceding the channel designator indicate that we are
affecting all I/O meters simultaneously.
Metering presets allow you to easily configure meter pairs. Pressing any of the
DSC Numeric keypad keys recalls these Meter selection presets. Following is
a list of the available presets:
KEY LEFT METER: RIGHT METER:
E Rev F Rev E Rev F Rev
[0] — Aud:OFF Aud:OFF Aud:OFF Aud:OFF
[1] — Aud:M1 Aud:M1 Aud:M2 Aud:M2
[2] — Aud:L3 Aud:L1 Aud:L4 Aud:L2
[3] — Aud:MT Aud:L3 Aud:L4 Aud:L4
[4] — Aud:LFL Aud:CMB Aud:LFR Aud:MT
[5] — Aud:UFL Aud:MT Aud:UFR Aud:CMB
[6] — Lvl:UF Aud:LFL Lvl:LF Aud:LFR
[7] — Lvl:M1 Aud:UFL Lvl:M2 Aud:UFR
[8] — - - - Lvl:UF - - - Lvl:LF
[9] — - - - Lvl:M1 - - - Lvl:M2
Pressing the DSC [ *ST ] key while the Meter Config menu is visible, switches
you into individual meter config mode. There is another way to set meter
modes for individual channels. Press a channel’s attention key located just
under the I/O channel’s meter array, then press [
F3 ] (METER):
For the global setup, press the DSC [ Mtrs ] key, then [ F2 ] (I/O):
Global Channel (I/O)
Meter Mode Selection
SIDE NOTE:
Assigning meter modes
globally by using the DSC
Mtrs key, always overrides
and changes any individual
channel meter assignments.
Metering Mode Presets
7 8 9
4 5 6
1 2 3
Individual Channel (I/O)
Meter Mode Selection
M
L
L
M
L
L
M
L
L
M1
M2
Out 1 Out 2 Out 3
ovld
Pwr
Pad
1 2
1 2
3 4
1 2
1 2
3 4
1 2
1 2
3 4
B
ovld
Pwr
Pad
Starting with unconfigured meters, attention is initially directed to the right
channel meter as indicated by the arrow between Aud and OFF shown above.
Press [
F2 ] to direct attention to the left meter:
F3 F1 F2 F4
1CH->Aud->OFF Aud:OFF