Euphonix MixView CS2000, Operation Manual

Page: 233 / 324

Section 9: Dynamics
Euphonix CS3000/2000 Operation Manual 9 - 17
For example, let's say that you want to assign all of the dynamics processors 1
per channel, except that you want to free up a pair of processors to insert on
the Stereo 1 bus. From the SmartDisplay, globally assign all of your dynamics
processors 1 per channel. Then find the
EQ•Dyn (1) and EQ•Dyn (2) keys on the
desk for the last pair of assigned processors. Enter the Patch menu from the
SmartDisplay and toggle [
EQ•Dyn ](1) and [ EQ•Dyn ](2) until the LEDs go out
and you can see (on the DSC screen) that the two processors have been de-
assigned. Now assign these two processors to the Stereo 1 bus by pressing
the attention key in that block.
Toggling assignments is useful if your console configuration varies only
slightly from the 1/channel or 2/channel defaults, since you won't have to
assign all of the dynamics processors manually. In addition, you can easily
swap processor assignments on the fly.
The DSC Route keys can sometimes be a useful shortcut to gain access to
dynamics processors, but this access has certain limitations:
1) There are only 48 DSC Route keys, so all processors numbered 49 and
above must be accessed from the EQ•Dyn(1) and EQ•Dyn(2) keys.
2) The DSC Route keys can access only Dyn1 processors 1-48 or Dyn2
processors 1-48 until switched into the other mode with an EQ•Dyn(1) or
EQ•Dyn(2) key.
You can assign a linked stereo pair of processors to either the Stereo 1 or
Stereo 2 buses by using [
F4 ] (Patch) in the Dynamics Assignment menu. Note
that when you assign dynamics 1/channel or 2/channel, all other dynamics
assignments are cleared, including any assignment to the stereo buses. Thus it
usually makes sense to assign a pair of dynamics to the stereo bus last.
When you assign dynamics to the stereo bus, the software automatically
assigns a linked pair of processors. These are always adjacent processors in
the same ES108A unit.
4
16 13 14 15
!
1
@
2
#
3 $
4
Q W E
1 2 3
tab
25
shft
26
A
27
S
28
D
You can also use the DSC
Route keys as a shortcut to
access individual dynamics
processors right from the DSC
EQ•Dyn
BUS
1
2
L
R
ovld
PAN BAL
EQ•Dyn(1) and EQ•Dyn(2) keys
are usually used to gain atten-
tion of dynamics processors
Assigning Dynamics to
the ST1 and ST2 Buses