Euphonix MixView CS2000, Operation Manual

Page: 188 / 324

Section 7: Automation
7 - 26 Euphonix CS3000/2000 Operation Manual
Edit Template
Edit Descriptions
Edit template color legend
Press [ F3 ] to view the template screen:
Here you will select the objects to be included in the edit operation by press-
ing the appropriate DSC Object key (Fader, Pan ,On etc.) and then pressing the
appropriate block attention key. Selected desk objects turn green for individual
objects, yellow for group master objects and blue when the selected object is
both a group master and underlying individual object. The color-coded legend
is shown at the bottom of the template screen.
Also in this screen, above the template you will see text briefly describing the
selected edit operation. To read each description, press [
F1 ] to sequence
through the other edit operations.
When finished making template selections, press [ F3 ] again to exit the tem-
plate and view the Pass Control screen.
The Edit region is defined by the Start and End times. Press [ F4 ] (T/C) to view
the edit regions Start and End points. Use [ F1 ] to toggle between “Start” and
“End” time. There are three ways to enter the Start and End points:
1. Manual timecode entry
2. Using Cue/Locate points
3. On-The-Fly while timecode is rolling
Use [ F1 ] to select “Start” time. Enter the timecode value starting with hours
using the Numeric keypad then press [ Enter ]. You will see the green “Start”
marker appear on the Pass Control screen. Press [ F1 ] to toggle to “End” and
enter the desired value again. You will see the red “End” marker appear on the
Pass Control screen. The timecode value can be nudged using the [
+ ]/[ – ] keys
or the SpinKnob. The system will not allow an End time to be entered which is
less than the Start time. If you attempt to enter a Start time which is later than
the End time, the End time is reset to the Start time.
Edit Region
Manual Timecode entry