Euphonix MixView CS2000, Operation Manual

Page: 285 / 324

Section 11: Hyper-Surround
Euphonix CS3000/2000 Operation Manual 11 - 5
The panner screen appears in the right half of the DSC screen display. Assum-
ing no panners have been built, all panners are blank.
The blue cursor is in the first block of the first panner. Press [ F2 ] to begin
selecting the panner format. While viewing the SmartDisplay menu, use the
SpinKnob or [
+ ]/[ - ] keys to scroll through the available formats until you see
“5.1”:
F3 F1 F2 F4
Notice that “5.1 L” appears in the Smart Display. It has automatically entered
L (left) as the first channel designation above F3.
If it is necessary to change the channel designation, press [ F3 ]. You will see
the flag move from next to the format designation to next to the channel
designation. Use the SpinKnob or [
+ ]/[ - ] keys to change the channel designa-
tion. Return the selection to “L”.
Now press [ F4 ] to assign the bus. Notice the flag moves to the Bus designa-
tion and the system will automatically select the first available bus in the
system. In our case bus 1 is selected because no other panners have been
built so no buses have been used. The SpinKnob or [
+ ]/[ - ] keys are used now
to change the bus selection if desired.
F3 F1 F2 F4
Press the [ right arrow ] key to move the blue cursor to the next block on the
panner screen. Press [ F2 ] again and notice that it has automatically entered
5.1 as the format and incremented the channel designation to C. Press [ F4 ] and
see that bus 2 is automatically selected.
Selecting a Format
Selecting a Channel
Selecting a Bus
P1-> 5.1:L B – –
P1-> 5.1:L B1
Next Block
SIDE NOTE:
The system is designed so that
from a blank panner menu,
pressing [
F2 ], [ F4 ] and the DSC
[ right arrow ] key repeatedly,
allows you to quickly complete
a panner setup. Continue this
sequence of key presses until
the 5.1 panner is complete.