Bootloader
VME-PMC-CADDY/2plus
Hardware-Manual • Doc.-No.: V.1915.23 / Rev. 1.0
Page 31 of 47
6.3 Booting VxWorks
Here are step-by-step instructions for booting VxWorks at the serial console. The tftp command
requires a correct U-Boot network configuration. That means the bootloader environment variables
ipaddr and serverip must be set up according to your network.
When any of the following steps fail, do not proceed!
1. Set the server IP:
ÉÊ
ËÌÍÌÎÏ
ËÌÐÏÌÐÑÒ
ÓÔÕÔÕÓÖÕ×Ø
2. Set the IP address:
ÉÊ
ËÌÍÌÎÏ
ÑÒÙÚÚÐ
ÓÔÕÔÕÓÖÕÓ×Û
3.You might need to set a gateway IP address:
ÉÊ
ËÌÍÌÎÏ
ÜÙÍÌÝÙÞÑÒ
ÓÔÕÔÕÔÕØ×
4. Set the VxWorks bootline:
ÉÊ
ËÌÍÌÎÏ
ßààÍÙÐÜË
áàÍÍËÌâãÔäÔåßààÍËÌÐÏÌÐÕæàâÙæçèéÍêÍÒßààÍéÏáÌëÖì×éÏíîàÐïËðÏáÌëÖì×
ñÉÓÔÕÔÕÓÖÕ×Ø
ÌÉÓÔÕÔÕÓÖÕÓ×Û
ÜÉÓÔÕÔÕÔÕØ×
ÍÎÉÏáÌëÖì×
òÉÏíÝàÐïË
ËÉéÍêÍÒßààÍéÏáÌëÖì×éÏíÝàÐïËéÏáÌëÖì×ÕßÙÍ
5. Loading the VxWorks image:
ÉÊ
ÍêÍÒ
ÓÔÔÔÔÔÔ
éÍêÍÒßààÍéÏáÌëÖì×éÏíîàÐïËðÏáÌëÖì×
6. Start VxWorks:
ÉÊ
ßààÍÏí
For further information about VxWorks read the
óôõö÷óøõ÷ù
-file. The
øõ÷ù
-file is contained in
the source of the VxWorks BSP.
