ESCO Technologies ETS-Lindgren EMControl 7006-001, User Manual

Page: 17 / 91

ets-lindgren.com EMControl Plug-In Card Installation 17
4.0 EMControl Plug-In Card Installation
CAUTION: : Before connecting any components, follow
the information in the ETS-Lindgren Product Information
Bulletin included with your shipment.
Caution: The EMControl card is designed to be used
ONLY with the EMCenter. Do not use the card in
combination with any other system.
Plug-In Card Installation
1. Determine in which em
pty slot in the EMCenter™ Modular RF Platform
you want to install the EMControl
™ Positioner Controller Plug-in Card.
Looking at the back of the EMCenter, the slots are numbered
1 through 7 from left to right.
2. Remove the blank panel from the slot by removing the two screws at
the top of the blank panel and the two screws at the bottom.
3. Carefully insert the EMControl card into the slot of the EMCenter.
Tighten the four screws.
4. Turn on the EMCenter. The EMCenter will automatically detect the
newly-installed EMControl card.
5. Depending on the test setup requirements, connect coaxial cables to
the relay connections on the back panel of the EMCenter.
6. Connect the EMCenter to a personal computer using USB, RS-232,
Ethernet, or IEEE (optional).
7. Plug the interlock into the connector on the back of the EMCenter.
The card installation is complete. You can control EMControl through the
EMCenter touchscreen, with ETS-
Lindgren TILE!™ (Totally Integrated
Laboratory Environment), ETS-
Lindgren EMQuest™ Data Acquisition and
Analysis Software, and other test automation software packages. Contact
ETS-Lindgren for additional information.