ES AWH11-V5+, User Manual

Page: 14 / 86

2.3.2 Installation
Indoor unit should be mounted on the wall as per procedures below:
1) Take out the expansion bolts and mounting board from accessory and put the mounting board on the
wall horizontally; Mark on the wall the location for bolts through the holes on mounting board.
2) Drill holes with proper diameter for expansion bolts.
3)
4)
5)
6) Hang the indoor unit onto the mounting board and make sure it's placed well before you let go
your hands. The installation is finished.
control
Unscrew the nuts out from the expansion bolts.
Fix the mounting board on the expansion bolts a little bit, but don't be too tight.
Use a hammer to pound the expansion bolts into the drilled holes. Fasten the nuts by turning the wrench
to fix the mounting board on the wall.
control
2. Installation
1
2 3
4 5 6
Note:
You must choose very firm wall for installation otherwise the bolts may get loose and unit be damaged!
If it's wood wall, please use self-tapping screws in accessory instead of bolts. Please hang
the mounting board directly onto the wood wall without drilling holes. The wood wall must be firm
enough. Wood walls that are too thin, too brittle or humid are not adequate for installation.
expansion
14