ERL L-PRO 4000, User Manual

Page: 37 / 406

2 Setup and Communications
D02706R02.30 L-PRO 4000 User Manual 2-15
2.13 Communication Port Details
Table 2.4: Communication Port Details
Location Port Function
Front Panel 119 RJ-45 receptacle, 100BASE-T Ethernet interface. Default IP =
192.168.100.80
Used for user interface access or SCADA access through Ether-
net LAN.
Front Panel 150 USB-B receptacle, High speed USB 2.0 interface
Used for user interface access
Default fixed baud rate 115,200 N81 (no parity, 8 data bits, 1 stop
bit).
Rear Panel 118 RJ-11 receptacle, Internal modem interface.
Default Baud rate 38,400 N81 (no parity, 8 data bits, 1 stop bit)
Rear Panel 119 Rear panel, RJ-45 receptacle or ST type optical receptacle (fac-
tory configured). 100BASE-T or 100BASE-FX (1300nm, multi-
mode) Ethernet interface. Same subnet as front panel port 119.
Used for user interface access or IEC61850/DNP SCADA access
through Ethernet LAN.
Rear Panel 120 ST type optical receptacle. 100BASE-FX (1300 nm, multimode)
Ethernet interface.
Used for user interface access or IEC61850/DNP SCADA access
through Ethernet LAN
Rear Panel 121 BNC receptacle, IRIG-B Interface. Modulated or un-modulated,
330 ohm impedance.
Rear Panel 122 RS-232 DCE female DB9.
Used for SCADA communication.
Default Setting: 19,200 baud O71 (odd parity, 7 data bits, 1 stop)
Rear Panel 123 RS-232 DCE female DB9.
Used for:
• User interface access through a direct serial connection.
• Default Setting: 9600 baud N81 (no parity, 8 data bits, 1
stop bit).
• User interface access through an external modem. The
optional ERLPhase Modem Adapter converts this port to a
Data Terminal Equipment (DTE) to simplify connection to
an external modem.