3 Using the IED (Getting Started)
3-8
L-PRO 4000 User Manual
D02706R02.30
Please refer to the Relay Control Panel User Manual for details.
4. Run Relay Control Panel.
Go to:
Start > All Programs > ERLPhase > Relay Control Panel > Relay Control
Panel
First time RCP is run.
Hit
Add New
.
“Add New Relay”
Choose Communication > Direct Serial Link.
Hit
Get Information From Relay.
Then RCP will communicate with the LPRO-4000 and retrieve in-
formation to fill required fields.
When this is done, hit
Save Relay
.
If the window “Relay already exists...” pops up, you may need to re-
name the relay changing the “Relay Name” in the “Relay Definition”
category, before saving.
After first time, in “Select Relay”, choose relay and hit
Connect
.
In “Relay Password Prompt”
Choose desired access level, enter appropriate password
Note: Default passwords are listed below (remove the quotation
marks)
View Access “view”
Change Access “change”
Service Access “service”
The basic structure of the Relay Control Panel information, including basic
actions available, is given below:
Table 3.5: Relay Control Panel Structure
View
Change
Service
Relay Control Panel
Records
Trigger Fault
Trigger Fault
Trigger Swing
Trigger Swing
Trigger Event
Trigger Event
Faults
Erase
Erase
Events
Erase
Erase
Metering
Summary of Contents for L-PRO 4000
