Ericsson EFN324, User Manual, Page: 132 / 176

IndexIndex
[enabled {no|yes}]
[link_trap_enabled {no|yes}]
[scheduling {none|sfq|sp|wfq}]
[speed {10|100}]
Arguments:
ethernet_port <port> ­
The number of the Ethernet port. Range 1­
26.
auto_negotiation no/yes
– Set up the line automatically (yes) or not.
crossover auto/no/yes
– Auto: The system does it automatically. No:
Straight through connection. Yes: Crossover set.
description –
Description.
duplex full/half
– The line is set up as full duplex or half duplex
connection.
enabled no/yes –
Operational state set by operator.
link_trap_enabled no/yes –
Defines whether changes in link state
(link up/down) for the port are sent as SNMP traps.
scheduling none/sfq/sp/wfq ­
Scheduling algorithm deciding the
order between packets sent over the egress port:

none = first in, first out

sfq = a combination of sp/wfq ( Modified Deficit Round Robin)

sp = strict priority

wfq =
weighted fair queuing (
Deficit Round Robin)
speed 10/100 ­
10 or 100 Mbps for Fast Ethernet (FE).
Note: In case the user needs to change the scheduling policy, e.g. asserting
the command
set ethernet_port <port> scheduling
{none|sfq|sp|wfq}
and on that
<port>
connections are
configured, then the configuration asserted will be visible in case a
get ethernet_port <port>
is asserted but the configuration will
be active on the hardware only after a
config save
and then a
restore
. This is outlined on the CLI by the following message:
*** WARNING!!!!