Technical and visual modifications as well as misprints reserved -
© 2015
by ERGO-FIT GmbH & Co. KG
Setup
6.4
Calibrating the Weight Plates
Before any new calibration/re-calibration of the weight plates you have to consider a warm-up
period of 35 minutes. The warm-up period starts as soon as you switch on the machine. Re-
calibration is only possible after the warm-up period has finished. Otherwise the weight plates
may be displayed incorrectly in the Cockpit or may adjust automatically.
Note: The workout machine with laser sensor is a precision measuring instrument. But even
here you have to consider measuring tolerances due to environmental factors (temperature
changes, operation time etc.). Therefore, we recommend to check the functionality of the
machine regularly. In case of a the weight plate difference you have to perform a re-
calibration.
6.5
Resistance adjustment
On all machines of the POWER LINE4000 series the resistance can be adjusted by adding
or reducing the number of snap-on weights. Dowel pins are used to adjust the weight by
inserting them into the borings in the snap-on weights. The weights may be chosen directly
from the machine.
AWhen adjusting, consider the following aspects:
⊗
You can only adjust the weights when the weight bundle is not under tensile stress
and the snap-on weights are resting firmly. Accordingly, you should avoid modifying
the training weight during a motion sequence.
⊗
Make sure to insert the dowel pins completely. If this is not the case, the pins might
loosen during motion. The snap-on weights can fall on the weight bundle and this
might damage the weights or injure the trainee because of jerky removal of the
load.
⊗
To secure the weights, insert the dowel pins straight into the borings. Otherwise, the
dowel pins might tilt during motion.
⊗
Do not put your hands between the snap-on weights. Otherwise, there is a risk of
injury
⊗
Do not let the weights impact on the weight bundle during and after exercise. Always
make sure that the weights fall smoothly on the bundle.
6.3.1
Additional Weight
Equipment with MED labeling provides an additional weight (2.5 kg) which can be added as
needed. Um dies zu tun müssen Just turn the yellow lever at the top of the weight stack.
4 4