Technical and optical modifications as well as misprints reserved -
© 2015
by ERGO-FIT GmbH & Co. KG
Transport and Setup
2 4
5.4
Ambient Temperature
⊗
Your ERGO-FIT exercise machine may be used at an ambient temperature of
+10°C to +40°C, a relative humidity of 30 to 75% (non condensing) and an
atmospheric pressure of 700 hPa to 1060 hPa without a problem.
⊗
The machine may be stored at a temperature between -30°C and +50°C.
5.5
Plugging in (POWER LINE 4100 only)
1.
Perform a visual inspection of the power cord and the input connector (power entry
module) before using the machine. Damaged power cords and connectors need to
be replaced immediately.
2.
Plug the power cord into the appropriate power entry module. Plug the other end of
the cable into the power outlet.
3.
Switch on the machine by pressing the power button (I = ON, O = OFF).
4.
After your exercise machine has been connected to mains and switched on, it
automatically carries out an operating check. During this operating check, you will
be able to read the software version of the unit on the display. Thereafter the main
menu will appear.
5.
Stand on the side of the control panel (view onto the display) and check if the
display works. If this is not the case, make sure you followed the steps above
correctly. In addition, verify if there is electricity in the mains socket.
5.5.1
Power Supply
Use your exercise machine only with earthed (grounded) power sockets with 230 VAC / 50-
60 Hz (see chapter A5). If you have any doubts about the power supply at the setup location,
ask your energy provider. Only use commercial 10 ampere automatic circuit breakers (type
B tripping characteristic). In the rare event that these automatic circuit breakers should switch
off when you switch on your machine, the circuit needs to be fused with 10 A (16 A with
TRAC) lead fuses or with a different type of tripping fuse (e.g. K-automat). In case of doubt,
ask your electrician.
Before connecting your ERGO-FIT exercise machine to your power supply system, compare
the acceptable voltage and frequency on the name plate (next to power entry module) with
your local data.
Always connect your machine directly to the power outlet. Do not use extension cables or
multi-outlet power strips unless they are EN 60601-1 certified.
We recommend DC-isolated cables for the connection of external equipment to a POWER
LINE 4000/4100 MED machine.