64
Fine-tuning the Projector
Controlling the Projector from a PC
Depending on how the projector is connected, you can use either the
EMP Link V software or a standard web browser to control the image
and sound, switch between video sources, and find out how long the
projection lamp has been in use. This is especially useful when the
projector is in a hard-to-reach location, as when ceiling-mounted or
set up for rear-screen projection.
Using EMP Link V
To use EMP Link V, you must install the projector software on your
system as described on page 52; the EMP Link V software is installed
along with it.
You must also connect the projector either over a network (as
described on page 31) or to a computer using a serial cable (see
page 22). If the projector is connected over a network, make sure
you’ve performed the setup steps described in “Configuring the
Projector” on page 48.
Starting EMP Link V
1. To launch EMP Link V, click
Start
,
Programs
,
EasyMP
, and
then
EMP Link V
. Select the program to launch it.
You see this screen:
