Epson 826W - PowerLite WXGA LCD Projector, User Manual

Page: 127 / 175

Solving Problems
127
■
Make sure you aren’t projecting one of the NS Connection
configuration screens. (You should see a message that the
projector is ready to connect.) If you have to exit a configuration
screen, restart NS Connection.
■
If the projector is configured for Access Point mode and you’re
using DHCP, allow time for your projector to appear. It takes the
server a little while to pick up the IP address.
■
If you’ve changed any settings for your projector or network, or
restarted your computer, allow a minute or two for the
connection to appear. If you’re using AirPort, try turning AirPort
off and then on again.
■
Make sure that you’re trying to connect to the right network. In
Windows, verify that you’ve enabled your computer’s connection
to the access point (see page 74) or that your wireless card or
adapter is enabled and its SSID is set to match the projector’s
SSID (see page 66). On a Mac, click the AirPort icon at the top of
your Mac desktop to make sure AirPort is turned on and the
projector’s SSID or your AirPort network is selected.
■
If you have an access point or AirPort base station and you’re not
using DHCP, check your projector’s IP address on the Access
Point mode advanced settings screen. The first three segments of
the IP address should be identical to the first three segments of the
IP address of your access point or base station. The last segment of
the projector’s IP address should be close, but not identical, to the
last segment of the IP address of the access point or base station.
■
If you’re not using DHCP, check your projector’s Gateway
address on the projector’s Access Point mode advanced settings
screen. It should be identical to the IP address for your access
point or AirPort base station.
■
If you’re using a projector keyword, it changes each time you turn
the projector off and then on again. Check the projector’s
keyword on the LAN standby screen and enter it at the prompt.