46
Installation Instructions - EmoTouch 3
Electrical installation
EN
5.6 Closing the relay box housing
The following work must be completed before you close the housing:
5.3 Setting the jumper for maximum heating time,
5.5 Connecting and configuring consumers,
7.3 Programming of the cabin address,
If the device is connected correctly and switched on, a green LED flashes
on the main circuit board after a short start-up period. This green LED sig-
nals normal communication.
See chapter Commissioning,
If the relay box in the utility room and the control panel are far apart, the
technician can identify the correct installation.
Replacing the housing cover
1
Switch on the relay box and check if the green LED is flashing.
a)
If the green LED is flashing, replace the housing cover.
b)
If the green LED is not flashing, troubleshoot the problem and resolve
it.
2
First put the lower then the upper cover halves in place.
3
Screw in the 6 screws.
