EOS 94 6505 00, Installation Instructions For Retailers

Page: 35 / 72

EmoTouch 3 - Installation Instructions 35
Electrical installation
Electrical installation
This chapter describes how to connect the relay box's circuit board lines.
For information on setup of the control panel, see chapter
Commissioning,

47.
You can connect both sauna heaters for Finnish mode and as Bi-O heaters.
Both types are referred to as sauna heaters in the following section. How-
ever, in instances where different settings must be made, they will be
referred to specifically by name.
Recommended installation sequence
Before commencing installation, ensure that the relay box, the control
panel, and the main sensor are mounted. Furthermore, all cabin work must
be complete: sauna heater, light, humidity sensor if required, etc.
Complete installation in the following sequence:

Plug the S-Bus and sensor lines into the relay box.

Connect the consumer lines (sauna heater, light, fan, etc.) to the relay
box.

Establish connection to the power supply.

In a multi-cabin installation: Program the cabin address.

Switch on the relay box and control panel.

Configure additional settings at the control panel, e.g. target tempera-
ture.