EOS 94 6505 00, Installation Instructions For Retailers

Page: 44 / 72

44 Installation Instructions - EmoTouch 3
Electrical installation
EN
4
Plug the sensor lines for the sensor into the free jack RJ10 (SENSOR).

The connected sensors are automatically detected and must be
configured on the control panel.

In a multi-cabin installation, the cabin address must also be
programmed. See 7.3 Programming of the cabin address,

63

Do not establish a connection to the power supply until you have
connected all lines and set all jumpers.
5.5 Connecting and configuring consumers
DANGER
Risk of electric shock
A faulty electrical connection poses the risk of an electric shock.
This risk also applies following completion of the installation work.

Disconnect the system entirely from the mains supply.

If retrofitting is required, the housing must only be opened by
trained personnel.

Electrical installation must only be carried out by a qualified and
licensed electrician.

The unit must be connected to the power supply according to
the circuit diagram and the terminal scheme.
Recommended sequence:

Connect the cabin lighting

Connect the fan

Connect the vaporiser if necessary

Connect the sauna heater
The entire output of the connected devices may not exceed the following
values:

For information about cabin lighting, see Light source requirements:,

22.

For information about the fan, see Fan requirements,

23.

Vaporiser 3 kW

Sauna heaters 9 kW
If the entire output exceeds these values, an additional circuit breaker must
be connected, e.g. LSG18H. See the installation instructions for the relevant
LSG.