7.2 Powerup test
The following instructions apply to the power up test.
The operation from the standard operator Frequency setting, Run and
stop command are controlled as follows :
Frequency setting select the potentiometer STOP/RUN : select the
RUN and STOP key
MCCB
L1
L2
U
V
W
P
RB
1
2
3
4
5
CM1
H
O/OI
L
FM
11
CM2
200V class
1-phase 200
¡
230V, 50/60Hz
Motor
Power
supply
Regenerative
braking resistor
Ground
ACTION (Digital operator control)
(1) Turn On the power supply by turning ON MCCB.
The [POWER] LED will illuminate.
(2) After checking that the potentiometer Enable LED is ON, set the frequency
by rotating the potentiometer.
(3) After checking that the RUN Enable LED is ON, press the key.
(4) The inverter starts running [RUN] LED is ON.
(5) Monitor the output frequency in the monitor mode
(6) Press the key to stop the motor rotation.
RUN
d 01
STOP
RESET
7-3
ENDA E-100
INSTRUCTION MANUAL