The OneCommand Utility User Manual
Page 4
Installing and Uninstalling OneCommand Manager
Application Components
Installing the OneCommand Manager Application
In Windows
The AutoPilot Installer
®
software streamlines the Emulex driver and OneCommand Manager application
installation. Refer to the Quick Installation Manual for more information. This manual is available on the
Emulex Web site for your driver version.
In Solaris SFS
The following must be installed before you can install the utilities:
•
The Solaris SFS driver version 2.50 or later
•
The Emulex Fibre Channel Adapter (FCA) utilities; refer to the FCA Utilities User Manual for
instructions on unpacking and installing the FCA utilities.
To install the OneCommand Manager application in Solaris SFS:
1.
Copy the Solaris utility kit to a temporary directory on your system.
2.
Untar the utility kit:
tar xvf elxocm-solaris-<version>.tar
3.
Change to the newly created elxocm-solaris-<version> directory:
cd ./elxocm-solaris-<version>/
4.
Execute the install script to begin installation. If the HBAnyware utility, OneCommand Manager
Core or OneCommand Manager Enterprise applications or the Solaris SFS driver utilities are
already present on the system, the install script attempts to remove them first:
./install
5.
When prompted, enter the type of management you want to use:
1 Local Mode : HBA's on this Platform can be managed by OneCommand
clients on this Platform Only.
2 Managed Mode: HBA's on this Platform can be managed by local or
remote OneCommand clients.
3 Remote Mode : Same as '2' plus OneCommand clients on this Platform
can manage local and remote HBA's.
6.
If you answered <2> or <3> in step 5, you are asked if you want the OneCommand Manager
application to operate in read-only mode. Read-only mode prevents users from performing
certain operations such as resetting adapters, updating an adapter's firmware and changing
adapter driver properties and bindings. It only affects the local OneCommand Manager
interface. These operations can still be performed using remote management. Enter <y> for yes
to allow the user to perform these operations, enter <n> for no if read-only mode is desired.
7.
You are prompted about allowing users to change the management mode after installation.
Enter <y> for yes, or <n> for no.
