19
b. Maximum frequency shown will be a little less than 8000 MHz, depending on the RBW, it
might even be less than 7950 MHz
Setting the pre-amp to Level 2 below 50 MHz may result in saturation
Noise floor smoothing and decimation of the noise signals are available through the user-controlled
Noise Reduction level and the Noise Threshold level
a. Noise Reduction Level 2 is incorrect. Do not use.
5. Spectral Comparison is fully supported
6. Spatial Comparison is fully supported
7. Spectral Overlay is fully supported
8. Report Generator is fully supported
9. Reset to factory default is enabled
10. Firmware Upgrades can be done over a Google Chrome (
never with Internet Explorer
)
Unsupported Features
1. Spectral scan peak marking not implemented yet
No inherited peak list will be generated in child spatial scan
2. Internal attenuation not supported
3. Probe compensation is not supported yet (for Far-Field Application)
Speed Information
1. Spatial speed per cell. Same above and below 50 MHz
RBW 30 kHz = 33 ms
RBW 122 kHz = 10 ms
RBW 976 kHz = 7 ms
2. Spectral speed per cell 0.15 MHz - 50 MHz span
RBW 30 kHz = 30 ms
RBW 122 kHz = 13 ms
RBW 976 kHz = 7 ms
3. Spectral speed per cell 50 - 1000 MHz span
RBW 30 kHz = 60 ms
RBW 122 kHz = 22 ms
RBW 976 kHz = 20 ms
To get the total scan time multiply by the number of cells. Note that you can set multiple sweeps per cell
to catch short bursts.
About EMxpert
EMxpert EHX+ Limitations
