Emerson Oxymitter 5000, Instruction Manual

Page: 4 / 226

HIGHLIGHTS OF CHANGES (CONTINUED)
Effective September, 2006 Rev 2.0 (Continued)
Page Summary
Page 3-2 Added Caution.
Page 4-1 thru 4-6 Added Section 4, Configuration of Oxymitter 5000 with LOI.
Page 5-1 thru 5-4 Pages 3-6 thru 3-10 in Section 3, Startup and Operation of Rev 1.6 was moved to Section
5, Startup and Operation of Oxymitter 5000 with Membrane Keypad.
Page 6-1 thru 6-10 Added Section 6, Startup and Operation of Oxymitter 5000 with LOI.
Page 7-1 Added body text under Overview.
Page 7-2 Added Figure 7-1, O
2
Sensor mV Reading vs. % O
2
at 736°C (Reference Air, 20.9% O
2
).
Page 7-4 Added Figure 7-2, Diagnostic LEDs.
Page 7-6 Removed Table 5-2, Calibration Fault Troubleshooting and Added Table 7-2,
Diagnostic/Unit Alarm Fault Definitions - LOI.
Page 7-7 thru 7-21 Added the LOI in Figures 7-3 thru 7-17 with descriptive text to accompany each figure.
Page 7-22 and 7-23 Added text and Figure 7-18, Probe Leakage Paths.
Page 8-0 Moved the "Calibration Record for Rosemount Analytical in Situ O
2
Probe", from the back
of the section to the front.
Page 8-6 and 8-7 Added information under the Calibration with LOI heading.
Page 8-7 Removed information regarding LED Status Indicators and Table 4-1, Diagnostic/Unit
Alarms from Rev 1.6.
Page 8-8 thru 8-21 Updated procedural steps throughout section.
Page 8-9 Removed Figure 4-4, Terminal Block from Rev 1.6. Updated Figure 8-3, Oxymitter 5000
with Integral Electronics - Exploded View, to show the LOI module and Window Cover.
Page 8-10 Added Figure 8-4, Oxymitter 5000 with Remote Electronics - Exploded View.
Page 8-15 Revised information under Heater Strut Replacement.
Page 8-17 Added Figure 8-9, Probe to Probe Head Assembly - Remote Electronics Only
Page 8-20 Revised Replacement Procedure for Ceramic Diffusion Element Replacement.
Page 8-21 Added Figure 8-12, Contact and Thermocouple Assembly Replacement.
Page 8-22 Removed information regarding the SPS 4000 Maintenance and Component
Replacement from pages 4-17 thru 4-24 in Rev 1.6.
Page 10-5 Added Figure 10-5, Catalyst Regeneration and corresponding text.
Page A-1 thru A-14 Moved Safety Instructions P-3 thru P-11 from the preface in Rev 1.6 to Appendix A in Rev
2.0.
Page B-1 Moved Section 10, Return of Material from Rev 1.6 to Appendix B in Rev 2.0.
Page C-1 thru C-6 Moved Appendix A in Rev 1.6 to Appendix C in Rev 2.0.
Page D-1 thru D-10 Moved Appendix B in Rev 1.6 to Appendix D in Rev 2.0.
Page E-1 Moved Appendix C in Rev 1.6 to Appendix E in Rev 2.0.