Emerson Daniel 3410 Series, Installation Manual

Page: 93 / 140

Shroud hanging on Shroud pin Figure 3-26:
3. Bring up the mating shroud, ensuring the transducer cabling falls within and is snug
in the shroud recess as before and hold in place.
4. Latch first the bottom shroud latch(s) followed by those on the upper side of the
shroud.
5. Thread the security seal's wire through the holes found on the latching lever side of
the mechanism and then through the seal mechanism itself. Pull the wire taught
then rotate the cranking tab until it snaps off.
Electrical installation
Installation manual 83