2009 by ELTRA GmbH Germany – July 2009 – Service Manual Thermostep
Page 6
c.)
Fasten the carouseladaptor with the 4 x 2,5 mm screws (respectivly 2 screws at 90°
shifted) through the two openings at the guidance (LHS). To fasten the screws
move the carouseladaptor until the screws are visible at the openings (see Fig. 1.2).
Fig. 1.2.: LHS – Guidance of Carouseladaptor (screws marked by red arrows)
If the carouseladaptor not located centrally at the notch of the lower heating element it has to
be
adjusted
, to avoid it rubbing at the borders of the notch!
Required tools:
2,0 mm Allenkey (angulate)
2,5 mm Allenkey
4,0 mm Allenkey
d.)
Remove the metal sheet round the lower heating element (inside furnace) by
loosen 6 x 2,0 mm screws (respectivly 3 screws at the left or rather at the right
border of the metal sheet) and 2 x 2,5 mm screws in front of the internal blower
(see Fig. 1.3).
