SMG Digital Gateway
405
(CgPNin, CdPNin, CgPNout, CdPNout) that passed fields belong to in the beginning of
the request.
Example:
For incoming communication, add 7383 to CgPN, change its number type to national and define
presentation restricted.
To do that, it is sufficient to pass the attribute with the following value in Access-Accept reply from the
RADIUS server:
Vendor-Specific(26): Eltex(35265): Eltex-AVPair(1):
CallManagement:7383;numtype=national;presentation=restricted
That is also equivalent to three attributes with the following values:
Vendor-Specific(26): Eltex(35265): Eltex-AVPair(1): CallManagement:7383
Vendor-Specific(26): Eltex(35265): Eltex-AVPair(1): CallManagement:CgPNin=;numtype=national
Vendor-Specific(26): Eltex(35265): Eltex-AVPair(1): CallManagement:CgPNin=;presentation=restricted
Call routing management
Using RADIUS server commands, you may manage the call routing process, i.e. to transfer it to another
dial plan of the gateway and unconditionally forward it to a prefix created in the configuration (equivalent to the
'direct prefix' parameter described in Section 3.1.7.1 Trunk groups).
Routing management command consists of the required part only:
'CallManagement:' is a text identifier defining that this attribute contains the call management
command.
'NumberingPlan' — identifier that indicates the dial plan change command.
'DirectRoutePrefix' — identifier that indicates the direct routing prefix selection command.
In general, command format will be as follows:
CallManagement:NumberingPlan=<$numplan_idx>
CallManagement:DirectRoutePrefix=<$prefix_index>
where
$numplan_idx — dial plan sequential number.
$prefix_index — ID of a prefix created in the dial plan.
Example
Change the call dial plan to the 3rd one.
Vendor-Specific(26): Eltex(35265): Eltex-AVPair(1): CallManagement:NumberingPlan=3
Call category management
Using RADIUS server commands, you may modify access category and subscriber's Caller ID category
(equivalent to the 'calling party category'). To do this, use the following fields:
Category changing command consists of the required part only:
