KOMET 200 - 600
21
ATTENTION!
The gate moves automatically during the next installation step.
19. During the following step the controller learns the running distance of the
(one or two) gate wings. Push the button
LERN
. The controller sends the
wing/wings into direction OPEN to the end stop and then into direction
CLOSED to the end stop. The display shows P2.
20. The gate is now in position CLOSED. Should the gate now be in position
OPEN, the wires 4 and 5 of the motor connection cable at the 5-pin
connection have to be switched. Then repeat by pressing button
BTG
once (1x - display
p1
) and pressing button
LERN
three times (3x - display
1f
,
ha
and
au
).
21. Push the button BT until
pp
is displayed. Confirm with button
LERN
.
22. Continue with paragraph - Programming MO36.
Shall the end position of one or both gate openers be changed, proceed us
described under 8.4 - Adjusting of the internal stops (KOMET 200 and 280).
You may also loosen the end stops separately and thus adjust them.
